WARNING – CHEMICAL AGENTS DOSAGE
Chemical agents dosage is performed through peristaltic pumps.
For each installed peristaltic pump the following control procedures are strongly encouraged:
1. Chemical dosage check– through flow sensors “flowmeter”;
2. Tank level check – through level sensors
Only when the control systems are installed can the device verify whether the dosage used complies
with the default setting and can warn the user of low dosage levels.
Control devices can be also installed upon use by technical staff authorized by the employer.
Please contact your trusted dealer for more information and clarifications.
Notes on variants - Power supply:
Unless otherwise specified, the device is set for a power supply of three-phase plus neutral with 400V
between phases (400V 3N~). This configuration is also referred to as "standard" (“std”).
To Next Page
Loading...
