182
Still Image Operations
This section describes the operation on frame memory
output channel 1 (FM1) as an example.
Creating a Still Image (Freeze)
You can assign a frame memory source bus signal to a
frame memory output channel and then execute a freeze
to capture still image content and save it in frame
memory.
When the system is powered off, the content in frame
m
emory will be lost. Also, if the channel assignment is
changed, unsaved content will be lost. Save any required
content in content storage.
For details about assigning a frame memory channel, see
“Setting DME/Frame Memory Channels” (page 399).
For details, see “Saving content to content storage”
(page 181).
1
Open the Home > Frame Memory > FM1/FM2 >
Clip/Still > Record menu (13101.13).
To enable group mode
Set the [Group Mode] button to the on state.
When group mode is enabled, the frame memory
o
utput channel display changes to [FM1/FM2].
2
Set the [Through] button for [FM1] to the on state.
The frame memory source bus signal is output on the
frame memo
ry output channel.
The output signal of the frame memory output
ch
annel is delayed by one frame.
3
Press the [Freeze] button for [FM1].
The still image content is saved in the folder specified
in
the properties for frame memory source 1.
To enable V/K mode
Set the [V/K Mode] button to the on state.
Recalling a Still Image
1
Open the Home > Frame Memory > FM1/FM2 >
Clip/Still > Recall menu (13101.11).
Content can be displayed in list view or thumbnail
vi
ew.
The frame memory output channels are shown on the
le
ft.
To enable group mode
Set the [Group Mode] button to the on state.
When group mode is enabled, the frame memory
out
put channel display changes to [FM1/FM2].
2
Select [FM1].
3
Select content to recall.
The selected content is recalled and displayed on the
f
rame memory output channel.
When group mode is disabled for frame memory
out
put channels and combined content is selected,
only content 1 of the combined content is recalled on
frame memory output channel 1.
Note
Note
Note