399
[MV/DME/CB] tab: Multi viewer, DME, color
background signals
[FM/CP] tab: Frame
memory and clip player signals
[Input] tab: I
nput signals
If the same signal is configured for multiple numbers,
th
e setting with the lowest number with the lowest
logical box ID becomes enabled.
5
Press [OK].
Setting DME/Frame Memory
Channels
You can set the DME/frame memory channels to use on
each box.
When the system signal format is 1080P or 1080i, all
bo
xes use the same channels.
• When a DME license (option) is not installed on a target
bo
x, DME channels cannot be assigned.
• When an SL key is selected in the GPU on a target box,
DME
channels cannot be assigned.
• If a target block does not have an M/E assigned, DME
ch
annels cannot be assigned.
• The DME channel assignment cannot be changed
un
less the DME channel 1 and 3 settings are the same
in the Home > Setup > System > Format/Config > GPU
Config menu (19101.25).
• If a frame memory channel is changed, the recall state
o
f all channels is released.
• If the frame memory channel is changed, unsaved
co
ntent will be lost. Save any required content in
content storage before making changes.
1
Open the Home > Setup > Switcher > Box Settings >
DME/FM Channel Assign menu (19103.53).
2
Select the target [DME Channel] group to set and
select the DME channels.
DME Ch1 / Ch2: DME
channel 1 and channel 2
DME Ch3 / Ch4: DME
channel 3 and channel 4
3
Select the target [FM Channel] group to set and select
the frame memory channels.
FM1 - FM6: Frame me
mory channel 1 to channel 6
FM7 - FM12: Frame
memory channel 7 to channel
12
4
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
5
Check the message, then press [OK].
Note
Notes
To Next Page
Loading...
