178
• Audio is recorded in video content, even if the video
content is created with audio disabled on a frame
memory output channel. Audio recording cannot be
disabled.
• To play audio, set the signal output to through mode.
For details about through mode, see “Setting Through
Mode” (page 374).
• In variable-speed playback, audio is not played.
• In loop playback, audio fades in at the playback start
po
int and fades out at the playback stop point. In
reverse playback, audio is not played.
• Noise may occur if a frame memory source bus or
f
rame memory output cross-point is switched during
audio playback.
• The audio sampling frequency when recording audio is
48 kHz only.
Importing/exporting
Frame memory content can be imported from a computer
using the Home > Content > Import/Export menu. You
can also export multiple content together as an archive
file and import an exported archive file into content
storage.
For details, see “Importing/Exporting Content”
(page 355).
Frame Memory
Operations
Assigning a Frame Memory Output
To output frame memory images to a monitor, for
example, the output signals from frame memory (FM1 to
FM16) must be assigned to cross-point buttons
beforehand.
For details about assignment, see “Creating a Cross-
Point Assign Table” (page 383).
Selecting an Input Signal
You can use the frame memory source 1 bus or 2 bus
signal for the input to frame memory.
Select a signal in a cross-point button row assigned with
th
e frame memory source 1 bus or 2 bus.
For details about selecting a signal, see “Chapter 4
Selecting Signals” (page 81).
Selecting a Frame Memory Output
Channel
Displaying the frame memory output
channel status
Open the Home > Frame Memory > FM Common >
Channel > Status menu (13109.31).
The status of the frame memory output channels is shown
on t
he left, and the properties of the content recalled on
the selected frame memory output channel are shown on
the right.
The following information is displayed in the frame
memor
y output channel status.
• Frame memory output channel
For combined channels, this is displayed in odd-
numb
ered channel/even-numbered channel format.
• Recalled content thumbnail
“No Thumbnail” is displayed if there is no thumbnail
fo
r the content.
• Name of recalled content
Notes
To Next Page
Loading...
