188
•MP4 file
Video: MPEG-4 AVC/H.264, 4:2:0 8-bit
Audio: AAC or PCM, 32 kHz/44.1 kHz/48 kHz, 16-bit/
24
-bit
MOV files and MP4 files may not be displayed correctly,
dep
ending on the content.
Audio content:
• WAV (PCM) file
32 kHz/44.1 kHz/48 kHz, 16-bit/24-bit
• M4A (AAC) file
32 kHz/44.1 kHz/48 kHz
Combined content
Content that combines two video content resources is
called combined content.
You can combine two video content resources with the
s
ame duration.
When group mode is enabled and combined content is
sel
ected, content 1 and content 2 of the combined content
are recalled on the two combined clip player output
channels, respectively.
For details, see “Combining Content” (page 353).
Audio playback
You can play audio using normal video content playback.
To play audio, first enable audio on the target clip player
ou
tput channel for operation.
• To play audio, set the signal output to through mode.
For details about through mode, see “Setting Through
Mode” (page 374).
• In loop playback, audio fades in at the playback start
po
int and fades out at the playback stop point.
• In variable-speed playback, audio is not played.
• Noise may occur if a clip player output cross-point is
s
witched during audio playback.
Importing/exporting
Clip player content can be imported from a computer
using the Home > Content > Import/Export menu. You
can also export multiple content together as an archive
file and import an exported archive file into content
storage.
For details, see “Importing/Exporting Content”
(page 355).
Clip Player Operations
Assigning Clip Player Outputs
To output clip player images to a monitor, for example,
the output signals from the clip player (CLIP1 to CLIP4)
must be assigned to cross-point buttons beforehand.
For details about assignment, see “Creating a Cross-
Point Assign Table” (page 383).
Selecting a Clip Player Output
Channel
Displaying the clip player output channel
status
Open the Home > Clip Player > Clip Common > Channel
> Status menu (14103.31).
The status of the clip player output channels is shown on
t
he left, and the properties of the content recalled on the
selected clip player output channel are shown on the right.
The following information is displayed in the clip player
out
put channel status.
• Clip player output channel
For combined channels, this is displayed in odd-
numb
ered channel/even-numbered channel format.
• Recalled content thumbnail
“No Thumbnail” is displayed if there is no thumbnail
fo
r the content.
• Name of recalled content
• Status icon
A thumbnail and content information are displayed in the
cont
ent properties.
Note
Notes
Icon Status
Black output
Video playback
Video stopped
Audio enabled
Audio disabled
Locked
To Next Page
Loading...
Need help?
General
