291
5
Check the message, then press [OK].
Renaming a register
A locked register cannot be renamed.
1
Open the Home > Register > Key Snapshot > Edit
Register > Browse menu (18303.11).
2
Select the target key to set.
For details, see “To select a key” (page 289).
3
Select the target register to rename.
To select and rename multipl
e registers, place a check
mark beside the target registers to rename.
To select and rename all registers, place a check mark
i
n the Select All checkbox.
You can also press the [Select Register(s)] button and
en
ter a register number in the numeric keypad
window.
4
Press the [Rename] button.
The [Rename] window appears.
5
Press the input field and enter a name (up to 8
characters) using the keyboard.
6
Press [OK].
Wipe Snapshot Register
Operations
Displaying a Wipe Snapshot
Register
Open the Home > Register > Wipe Snapshot > Edit
Register > Browse menu (18304.11).
You can check the following information.
[Region] group region display:
Displays the selected switcher bank.
Register list:
Displays a list of registers for the selected switcher
ban
k.
• Register number
•Register name
• Lock icon
A lock icon is displayed when a register is locked.
To select a switcher bank
1
Press the [Select] button in the [Region] group.
The [Select Region] window appears.
2
Set the button for the target switcher bank to the on
state.
3
Press [OK].
Editing a Wipe Snapshot Register
You can copy, move, and swap register data. You can also
rename, lock, and delete a register.
Copying a register
• An empty register cannot be copied.
• A locked register cannot be copied.
1
Open the Home > Register > Wipe Snapshot > Edit
Register > Copy/Move/Swap menu (18304.12).
A list of copy source registers is shown on the left,
and
a list of copy destination registers is shown on the
right.
2
Press the [Select] button in the [Region] group on the
left.
The [Select Region] window appears.
Note
Notes
To Next Page
Loading...
Need help?
General
