Sony MLS-X1 - Bus Override; Snapshot Operations (Flexi Pad Control Block)

279
Configurable attributes
The attributes that can be configured vary depending on
th
e region.
a: Av
ailable
×: Not available
a) Aux 1 to Aux 48 regions only
b) Color Bkgd 1, Color Bkgd 2, Aux 1 to Aux 48 regions only
c) Frame Memory 1 to Frame Memory 16, Clip Player 1 to Clip Player 4
re
gions only
Temporary attributes
Apart from attributes set in a snapshot register, you can
add temporary attributes when a snapshot is recalled. You
set temporary attributes when recalling a snapshot.
Bus Override
This function is used to recall a snapshot while
maintaining the cross-point selection of background A
bus or B bus.
When you press and hold a background A bus or B bus
cross-po
int button and recall a snapshot, the cross-point
selection state is maintained for the pressed button only.
This is useful for temporarily holding a cross-point
sel
ection when cross-point hold is not set.
Snapshot Operations
(Flexi Pad Control Block)
In the Flexi Pad control block, you can perform
operations on snapshots for switcher bank region targets.
You can save and recall a snapshot using the Flexi Pad
cont
rol block of the target switcher bank.
Memory recall section in snapshot
operation mode
Pressing the [SNAPSHOT] button in the Flexi Pad
control block switches the memory recall section to
snapshot operation mode.
You select registers (1 to 999) and set attributes using the
b
uttons in the memory recall section.
To allow operations on the 999 snapshot registers, the
Fl
exi Pad control block groups the registers. A register
group is called a bank.
There are 100 banks (0 to 99) and you display and select
th
e bank corresponding to the target register.
Ten registers are displayed in each bank. Bank 0 displays
r
egister numbers 1 to 9, bank 1 displays register numbers
10 to 19, and so on.
The currently selected bank number and register number
ar
e displayed on the top right button in the memory recall
section.
A register number is not assigned to the bottom left button
of
bank 0. You can assign any register number.
For details, see “Assigning a register to bottom left
button of bank 0” (page 419).
Selecting a bank
You can switch banks using the following buttons.
To select bank 0: Press the [BANK0] button.
To select bank 1: Press the [BANK1] button.
To select bank 2: Press the [BANK2] button.
To select bank 0 to 99: Press the [BANK SEL] button and
ent
er a bank number (0 to 99) using the numeric
keypad in the memory recall section.
To select the previous bank, press the [PREV BANK]
but
ton in the memory recall section.
To select the next bank, press the [NEXT BANK] button
i
n the memory recall section.
Selecting a register
The selected bank register is displayed in the memory
recal
l section. Press the button for the target register to
select it.
The register name or register number is displayed on
but
tons for registers with a registered snapshot.
Attributes Switcher
bank
regions
User
regions
DME
regions
External
device
regions
Cross-point
ho
ld
a a
a)
× a
Auto transition a × × ×
Effect dissolve a a
b)
a ×
Auto play × a
c)
× ×
Cross-point
ho
ld (DME)
× × a ×
Note