289
Renaming a register
A locked register cannot be renamed.
1
Open the snapshot register display menu.
To rename a multi region register
Open the Home > Register > Snapshot > Edit
R
egister > Browse Multi Rgn menu (18302.11).
To rename a single region register
Open the Home > Register > Snapshot > Edit
R
egister > Browse Single Rgn menu (18302.12).
2
Select the target region to set.
For details about selecting multiple regions, see “To
select a region” (page 285).
For details about selecting a single region, see “To
select a region” (page 286).
3
In the list on the left, select the target register to
rename.
To select and rename multipl
e registers, place a check
mark beside the target registers to rename.
To select and rename all registers, place a check mark
i
n the Select All checkbox.
You can also press the [Select Register(s)] button and
en
ter a register number in the numeric keypad
window.
4
Press the [Rename] button.
The [Rename] window appears.
5
Press the input field and enter a name (up to 8
characters) using the keyboard.
6
Press [OK].
Key Snapshot Register
Operations
Displaying a Key Snapshot Register
Open the Home > Register > Key Snapshot > Edit
Register > Browse menu (18303.11).
You can check the following information.
[Key Region] group region display:
Displays the selected switcher bank and key.
Register list:
Displays a list of registers for the selected key.
• Register number
•Register name
• Lock icon
A lock icon is displayed when a register is locked.
To select a key
1
Press the [Select] button in the [Key Region] group.
The [Select Key Region] window appears.
2
Set the button for the target key to the on state.
3
Press [OK].
Editing a Key Snapshot Register
You can copy, move, and swap register data. You can also
rename, lock, and delete a register.
Copying a register
• An empty register cannot be copied.
• A locked register cannot be copied.
1
Open the Home > Register > Key Snapshot > Edit
Register > Copy/Move/Swap menu (18303.12).
A list of copy source registers is shown on the left,
and
a list of copy destination registers is shown on the
right.
2
Press the [Select] button in the [Key Region] group
on the left.
The [Select Region] window appears.
3
Set the button for the copy source key to the on state.
4
Press [OK].
Note
Notes
To Next Page
Loading...
Need help?
General
