407
The setup operation ends and the buttons stop
flashing.
To set a name
Press the [Name] button and enter a name (up to 8
cha
racters) using the keyboard.
When multiple buttons are selected, consecutively
nu
mbered names are set.
For details, see “Name settings when multiple items are
selected” (page 78).
To release the assignment
Select the target button to release and press the [Clear]
bu
tton.
Inhibiting DME Channel
Operations
You can inhibit DME channel selection operations in the
device control block.
1
Open the Home > Setup > Panel > Module > DME
Channel Inhibit menu (19104.23).
2
Select the target DME channel to set.
To select and set multiple DME channels, place a
chec
k mark beside the target DME channels to set.
To select and set all DME channels, place a check
mark i
n the Select All checkbox.
3
Set the [Inhibit] switch to the on state.
To Next Page
Loading...
