Sony MLS-X1 - Page 261

261
4 Enter an effect duration in the numeric keypad area in
the numeric keypad control block.
Enter a duration as a timecode
(mi
nute:second:frame).
You can also enter a difference value from the
cu
rrently set value using the [TRIM] button.
For details, see “Entering a difference from a current
value” (page 79).
5 Press the [ENTER] button.
The effect duration is applied.
Setting the keyframe duration
• In constant duration mode, it is not possible to set the
keyframe duration.
• You can set a default value for the keyframe duration.
For details about settings, see “Setting the default
keyframe duration” (page 420).
1 Press the [KF MCRO EDIT] button.
The memory recall section switches to effect
t
imeline/macro edit mode.
2 Press the [EDIT ENBL] button, turning it on orange.
3 Select an edit point (keyframe).
The time from the selected keyframe to the following
ke
yframe is the target to set.
4 Press the [KF DUR] button.
“KF DUR XXX:XX” (“XXX:XX” is the current
k
eyframe duration) is displayed on the display in the
numeric keypad control block.
5 Enter a keyframe duration in the numeric keypad area
in the numeric keypad control block.
Enter a duration as a timecode (second:frame).
You can also enter a difference value from the
cu
rrently set value using the [TRIM] button.
For details, see “Entering a difference from a current
value” (page 79).
6 Press the [ENTER] button.
The keyframe duration is applied.
Setting the delay
1 Press the [KF MCRO EDIT] button.
The memory recall section switches to effect
t
imeline/macro edit mode.
2 Press the [EDIT ENBL] button, turning it on orange.
3 Press the [DELAY] button.
“DELAY XXX:XX” (“XXX:XX” is the current
del
ay) is displayed on the display in the numeric
keypad control block.
4 Enter a delay in the numeric keypad area in the
numeric keypad control block.
Enter a delay as a timecode (second:frame).
You can also enter a difference value from the
cur
rently set value using the [TRIM] button.
For details, see “Entering a difference from a current
value” (page 79).
5 Press the [ENTER] button.
The delay is applied.
Note
Notes
Note
Note