Chapter 17 Files
1018
Operations on Individual Files
Loading Files
As an example, to load a snapshot file from hard disk or memory card to a
register, use the following procedure.
1
In the File menu, select VF3 ‘Snapshot’ and HF1 ‘Snapshot.’
2
In the device selection area on the left, select [Register].
3
In the device selection area on the right, select where the file is held
([HDD] or [Memory Card]), and then specify a directory.
See “Selecting a Device for Operations” (page 1015).
4
Using any of the following methods, select the register to which you want
to load, and the file to be loaded.
• To select all files within the list, press [ALL] below the list.
• To select multiple files, turn the knobs to select in the following ranges.
• To select a single file, press the arrow keys to scroll the reverse video
cursor, or press directly on the list in the status area.
5
Press [T Load].
This loads the contents of the selected file from the specified location.
(Setup data is first loaded.)
Loading frame memory files
Between steps 3 and 4 of the procedure above, “Loading Files,” do as follows.
1
To select the frame memory folder, press [Default] in the device selection
in the list on the left.
A pull-down menu appears.
2
Press the required folder name.
3
Carry out the same operations as in steps 1 and 2 on the list on the right.
Knob Parameter Adjustment Setting values
1 List L Select the first register into which the
data is to be loaded
1 to 99
2 List R Select the first file in which data is held 1 to 99
3 Num Number to be selected 1 to 99
To Next Page
Loading...
