Sony MVS-8000 - Metal Settings

Chapter 11 DME Operations
653
DME Special Effect Operations
• To select the signal to mix with the relief pattern for Relief
In the <Chroma Type> group, select the signal to mix with the relief
pattern.
Matte: Select a single color. The following parameters can be adjusted.
Video: Select the input video signal.
6 To invert white and black in the extracted video, or to invert the outlines
and the sections other than the outlines, press [Nega], turning it on.
Masking the Sketch effect with a selected pattern
Press [Mask] to display the Mask menu and set the type of pattern and
modifiers.
For details, see “Mask Settings” (page 657).
Notes
The Mask function is not supported on the MVE-8000.
Metal Settings
Notes
The Metal function is not supported on the MVE-8000.
Applying the Metal effect
1 In the DME menu, select VF7 ‘Enhanced Video Modify’ and HF2 ‘Metal.’
The Metal menu appears.
2 Press [Metal], turning it on.
This enables the Metal effect.
3 Set the parameters.
Knob Parameter Adjustment Setting values
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
Knob Parameter Adjustment Setting values
1 Mix Ratio Mix amount for Metal video and
input video
0.00 to 100.00