Chapter 7 Frame Memory
430
External Hard Disk Drive Access
4
Press [Yes].
This starts the file saving operation. If there is no directory in the logical
drive, a directory is automatically created, and the files are saved within it.
A progress bar and numerical indication appear to show the progress of the
operation.
When the operation is completed, a popup window reading “Completed.”
appears.
5
Press [OK].
To rename a directory
Select a directory in the list, and in the button area press [Rename].
In the keyboard window that appears, enter the new directory name, and press
[Enter]. The name of a directory is limited to eight characters.
Notes
The following names cannot be used:
CON, PRN, AUX, CLOCK$, NUL, COM0, COM1, COM2, COM3,
COM4, COM5, COM6, COM7, COM8, COM9
LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6, LPT7, LPT8, LPT9
Recalling Files
You can recall all of the saved files on the hard disk drive into frame memory.
1
Carry out steps 1 and 2 of the procedure “Saving Files” (page 429).
Notes
It is not possible to select a directory (logical drive) on which files are not
saved.
2
In the <Restore> group, do either of the following.
• To replace the existing data with the recalled data, press [Replace].
• To add the recalled data to the existing data, press [Append].
A popup window for confirming file recall appears.
Notes
When you execute [Replace], any existing data in frame memory is lost
immediately before the recalling operations.
To Next Page