Chapter 3 Signal Selection and Transitions
151
Signal Selection
Signal Assignment and Selection
Assigning signals to buttons
Each of the 32 cross-point buttons and reentry buttons has a corresponding
button number, to which you assign a signal.
In addition to the signals input to the PRIMARY INPUTS 1 to 80 connectors
(1 to 34 connectors for the MVS-8000SF/8000ASF/8000GSF) on the rear
panel of the switcher, you can also select signals generated within the switcher.
Each button has assigned to it a video signal and a key signal, forming a pair.
You can set these video and key combinations in a Setup menu.
For details of Setup menu operations, see “Cross-Point Settings (Xpt Assign
Menu)” in Chapter 19 (Volume 3).
Cross-point button control block button numbers
On each M/E bank and the PGM/PST bank, each cross-point button and reentry
button has two button numbers, and you use the shift button to switch between
these numbers.
In the case of a 32-button layout, the button numbers are as follows.
(first button numbers)
(second button numbers)
Shift button
Shift button
Cross-point control block button numbers
Button Number when the shift
button is not pressed
Number when the shift
button is pressed
From the left end to the
31st button
1 to 31 32 to 62
Reentry buttons 121 to 123 125 to 127
To Next Page
Loading...
