Chapter 23 Setup Relating to Router Interface and Tally (Router/Tally)
1304
Serial Tally Settings (Serial Tally Menu)
• Press directly on the list on the left of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
4
Turn the knob to select the source address.
5
Press [Source Address Set].
This confirms the setting.
Clearing a Source Address Setting
To clear a source address setting for a particular bit
In the Router/Tally >Serial Tally >Source Assign menu, select the serial tally
port and bit number (see steps 2 and 3 in the previous item), then press [Clear].
This clears the source address setting for the selected bit.
To clear all source address settings
In the Router/Tally >Serial Tally >Source Assign menu, select the serial tally
port, then press [All Clear].
A confirmation message appears.
• If you select “Yes,” this clears all source address settings for the selected
serial tally port.
• If you select “No,” the clear operation is canceled.
Knob Parameter Adjustment Setting values
1 Bit No Bit selection 1 to 128
Knob Parameter Adjustment Setting values
2 Source Addr Source address selection 1 to 1024
To Next Page
Loading...
