Sony MVS-8000 - Setting the Delay

Chapter 13 Keyframe Effects
847
Time Settings
Notes
In addition to the above operation, the effect duration may also be changed
as a result of inserting or deleting keyframes. See “Time Settings” (page
800).
Setting the Delay
To set the delay (see “Time Settings” (page 800)), use the following procedure.
1 Press the [EDIT ENBL] button, turning it on.
2 Press the [DELAY] button, turning it on.
The display in the numeric keypad control block shows “DELAY”
followed by the delay time (seconds:frames).
3 Using the numeric keypad in the numeric keypad control block, enter the
timecode value for the delay, as a maximum of four digits.
You can also use the [TRIM] button to enter a difference value. (See “To
enter a difference value” (page 829).)
4 Press the [ENTER] button to confirm the entry.
This changes the delay setting.