Chapter 11 DME Operations
643
DME Special Effect Operations
Blur Settings
Applying the Blur effect
1
In the DME menu, select VF2 ‘Video Modify’ and HF1 ‘Defocus/Blur.’
The Defocus/Blur menu appears.
2
Press [Blur], turning it on.
The Blur effect is enabled. You can adjust the blurring of video and key
signals with the knobs.
Notes
On the MVE-8000A, the Glow and Blur effects cannot be enabled at the
same time. The effect which was turned on most recently is enabled.
3
When the MVE-8000A/MVE-9000 is connected through an SDI interface,
in the <Blur Mode> group, select the signal to which you want apply the
Blur effect.
Video/Key: Video signal and key signal
Video: Video signal only
Key: Key signal only
4
Set the parameters.
• When the DME dedicated interface is used
• When Video/Key is selected (with SDI-interfaced MVE-8000A/
MVE-9000)
Knob Parameter Adjustment Setting values
1 H Horizontal defocusing of video
and key signals
0.00 to 100.00
2 V Vertical defocusing of video and
key signals
0.00 to 100.00
3 All Horizontal and vertical
defocusing of video and key
signals
H value shown
Parameter group [1/2]
Knob Parameter Adjustment Settings values
1 V/K H Horizontal defocusing of video
and key signals
Video H value shown
2 V/K V Vertical defocusing of video and
key signals
Video V value shown
To Next Page
Loading...
