Sony MVS-8000 - Recalling Still Images

Chapter 7 Frame Memory
390
Still Image Operations
source bus 1. The pair setting cannot be used to set the frame memory
source bus 2. If you want to set video process for frame memory source bus
1 only with the pair setting when old settings for frame memory source bus
2 remain, return the frame memory source bus 2 settings to their default
values. When setting video process for the frame memory source bus 2,
disable the pair setting.
Setting a mask
Masks can be set separately for frame memory source buses 1 and 2. To apply
a mask to the signal selected on frame memory source bus 1, for example, use
the following procedure in the Still >Freeze/Store menu.
1 Press [Box Mask] turning it on.
2 Use the knobs to adjust the following parameters.
3 To link the masks on frame memory source buses 1 and 2, press [Mask
Link], turning it on.
Recalling Still Images
You can recall an image file saved in memory, and allocate to any of the FM1
to FM8 outputs.
Recalling a still image
To recall a still image file saved in memory using the thumbnails, and assign it
to an FM output, use the following procedure.
1 In the Frame Memory menu, select VF1 ‘Still’ and HF1 ‘Recall.’
The Recall menu appears.
• When [Pair] is on, only pair files (pairs of main file and sub file) are
displayed.
• When [Pair] is off, both single files and pair files appear (see following
figure).
Knob Parameter Adjustment Setting values
1 Top Top position –100.00 to +100.00
2 Left Left position –100.00 to +100.00
3 Right Right position –100.00 to +100.00
4 Bottom Bottom position –100.00 to +100.00