Chapter 11 DME Operations
728
DME Special Effect Operations
• When executing combining four channels of DME images, “Mix Color”
and “Ext Video” cannot be selected.
2
Only if Flat Color is selected in step 1, adjust the following parameters.
Separate Sides Settings
Applies separate video signals and key signals to the front and back of the
image.
Applying the Separate Sides effect
1
In the DME menu, select VF6 ‘Input/Output’ and HF2 ‘Video/Key.’
The Video/Key menu appears.
2
Press [Separate Side], turning it on.
The Separate Sides effect is enabled. If the video and key signals currently
being output to the monitor are the front side, you can select the front
signals. If they are the back side, you can select the back signals. Video and
key signals are selected with the cross-point control blocks of each M/E
bank or the PGM/PST bank.
Shaped Video Settings
For each of the front and back sides of the image, specifies whether to handle
input video from the switcher as shaped video (key processed signals).
You can also make these settings for the output video.
Notes
• When using an SDI interface, with the [PROC KEY] not selected in the
output destination buttons, then the shaped video function is enabled.
• When using the dedicated interface or SDI interface, with [PROC KEY]
selected in the output destination buttons, since the input video signal to the
first channel is always set to the key processed signal on the switcher, the
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
To Next Page
Loading...
