Chapter 16 Macros
939
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
Macro Operations in the Numeric Keypad
Control Block and the Keyframe Control
Block
This section describes macro operations carried out in the numeric keypad
control block and the keyframe control block.
Notes
For a macro take operation (see “Macro Execution” (page 938)), the numeric
keypad control block and keyframe control block are not used. Use the [Take]
button in the Flexi Pad control block.
For an overview of macros, see “Macros” (page 932).
For macro operations in the numeric keypad control block, use the following
buttons. (See the figure on next page.)
MCRO button
UNDO button
STORE STATS button
Display
STORE button
RCALL button
Numeric keypad
To Next Page
Loading...
