EasyManua.ls Logo

Sony MVS-8000 - Preparations

Sony MVS-8000
1364 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 9 Color Corrector
462
Preparations
Preparations
The color corrector enables video signal color correction (black balance/white
balance adjustment, gamma correction, knee correction, etc.).
Notes
To use the color corrector on the MVS-8000A, the MKS-8420M Color
Corrector Board is required. To use the color corrector on the MVS-8000G
requires the MKS-8442G Frame Memory Board and BZS-8420 Color
Corrector Software. To use the software, you are required to input an install
key.
For the method of inputting an install key, see “Installation and Device Setup
(Install/Unit Config Menu)” in Chapter 18 (Volume 3).
Note on using a format other than 720P
When using the color corrector on a 4M/E system: It is not possible to use
an M/E reentry signal in an overlaid manner on the key bus or utility 1 bus.
Example 1: When M/E-1 is selected on the M/E-2 background A bus (or
background B bus, key bus, utility 1 bus, or utility 2 bus), it is not
possible to select M/E-2 on the M/E-3 key bus or utility 1 bus.
Example 2: When M/E-2 is selected on the M/E-3 background A bus (or
background B bus, key bus, utility 1 bus, or utility 2 bus), it is not
possible to select M/E-3 on the PGM/PST key bus or utility 1 bus.
Note on using 720P format
The following restrictions apply depending on the system configuration.
Restriction 1: M/E reentry signals cannot be selected on the key bus and utility
1 bus. For example, you cannot select M/E-1 on the M/E-2 key bus or
utility 1 bus.
Restriction 2: It is not possible to use an M/E reentry signal in an overlaid
manner on the key bus or utility 1 bus.
Example 1: When M/E-1 is selected on the M/E-2 background A bus (or
background B bus, key bus, utility 1 bus, or utility 2 bus), it is not
possible to select M/E-2 on the M/E-3 key bus or utility 1 bus.
Example 2: When M/E-2 is selected on the M/E-3 background A bus (or
background B bus, key bus, utility 1 bus, or utility 2 bus), it is not
possible to select M/E-3 on the PGM/PST key bus or utility 1 bus.
When using the color corrector on a 3M/E system with a board with
multi-format support
The above restriction 2 applies.

Table of Contents