Sony MVS-8000 - Snapshot Register Editing

Chapter 14 Snapshots
904
Snapshot Operations in the Menus
• In the menu control block, press the top menu selection button
[SNAPSHOT].
• In the numeric keypad control block, press the [SNAPSHOT] button
twice in rapid succession.
The Snapshot menu appears.
2 Press VF1 ‘Master Snapshot’ and HF1 ‘Store.’
The Master Snapshot >Store menu appears.
The status area shows the master snapshot register names, register lock
status, register number for each region, and so on.
3 If required, press the following buttons in the status area to change the
region display.
M/E, P/P: indicate assignment of M/E-1 (“M/E1”), M/E-2 (“M/E2”), M/
E-3 (“M/E3”), and P/P (“P/P”).
User: User1 (“USR1”) to User8 (“USR8”)
DME: indicate assignment of DME ch1 (“DME1”), ch2 (“DME2”), ch3
(“DME3”), ch4 (“DME4”), ch5 (“DME5”), ch6 (“DME6”), ch7
(“DME7”), and ch8 (“DME8”).
Misc: RTR (“Router”)
Snapshot Register Editing
You can carry out the following editing on snapshot registers.
(You can use similar procedures also on master snapshot, wipe snapshot, DME
wipe snapshot and key snapshot registers.)
• Lock: Write-protect the contents of the register.
• Copy: Copy the contents of one register to another register.
•Move: Move the contents of one register to another register.
• Swap: Swap the contents of two registers.
• Delete: Delete the contents of a register.
• Name: Attach a name to a register.
For details of snapshot register operations, see “Effect Register Editing”
(page 867).