Chapter 4 Keys
216
Key Setting Operations Using Menus
Key Type Setting
Setting the key type in a menu
1
In the M/E-1 >Key1 menu, select HF1 ‘Type.’
The Type menu appears.
2
In the <Key Type> group, select the key type.
Luminance: luminance key
Linear: linear key
Chroma: chroma key
Color Vector: color vector key
Wipe Pattern: wipe pattern key
Key Wipe Pattern: key wipe pattern key
For the selected key type, you can now set the parameters.
For an overview of the key types, see “Key Types” (page 208).
3
Carry out the following settings as required, depending on the key type
selected in step 2.
To enable clean mode (see page 208) for a luminance key, linear key or
color vector key: Select [Clean Mode] so that it is set on.
When clean mode is enabled, key fill is added to the background
without cutting out with key source.
When chroma key is selected: Select [Chroma Adjust] to access the
Chroma Adjust menu (see page 221), and make the required settings.
When a wipe pattern key is selected: In the M/E-1 >Wipe menu (see
page 289), select the pattern and set any modifiers, then return to the
M/E-1 >Key1 menu.
When a key wipe pattern key is selected: In the M/E-1 >Key1 >
Transition >Wipe Adjust menu (see page 315), carry out pattern
selection and modifier setting, then return to the M/E-1 >Key1 >Type
menu.
Notes
For a wipe pattern selected for a wipe pattern key or key wipe pattern key,
the [Edge] and [Direction] modifier settings are not available.
4
Set the parameters.
To Next Page
Loading...
