Chapter 11 DME Operations
731
DME Special Effect Operations
Applying the Invert effect
1
In the DME menu, select VF6 ‘Input/Output’ and HF2 ‘Video/Key.’
The Video/Key menu appears.
2
In the <Front> group (to invert front signals) or the <Back> (to invert back
signals), press the following buttons, turning them on.
H Invert: Invert video and key signals horizontally.
V Invert: Invert video and key signals vertically.
Key Density Settings
You can adjust the key density for the key signal input to the DME.
Setting the key density
1
In the DME menu, select VF6 ‘Input/Output’ and HF2 ‘Video/Key.’
The Video/Key menu appears.
2
Press [Key Density], turning it on.
This enables the key density function, and you can now use the knobs to
adjust the parameters.
3
Set the following parameter.
Key Source Selection
You can select either the key signals received from the switcher or the key
signals generated in the DME for application to the front and back of the image.
Knob Parameter Adjustment Setting values
1 Key Density Key density 0.00 to 100.00
To Next Page
Loading...
