Chapter 11 DME Operations
709
DME Special Effect Operations
Mix Color: Insert a mix color signal (see page 638) in the afterimage portion.
Ext Video: Insert the external video signal input to the Ext IN connector in the
afterimage portion.
Rainbow: Use a freeze image with the hue changing every frame in the
afterimage portion. The difference from “Hue Rotate” is that many colors
appear simultaneously.
For details of the Rainbow parameters, see the “Hue Rotate” item above.
Applying modulation to the afterimage portion (Modulation)
1
In the Wind menu, press [Modulation], turning it on.
2
Set the following parameters.
For details of Priority, Wind Freeze Timing, Wind Eraser, Defocus, Dust, and
Combine Process in the Wind menu, see “Trail Settings” (page 699).
Spotlighting Settings
You can set up to three light sources (lights 1 to 3).
Notes
• The Spotlighting effect is not supported on the MVE-8000/8000A.
• The BZDM-9050 Texture Lighting Software (for MVE-9000) is required to
set lights 2 and 3.
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Speed Rate at which hue changes –12.00 to +12.00
Knob Parameter Adjustment Setting values
1 Amp H Horizontal amplitude of the
wave
0.00 to 100.00
2 Freq H Horizontal frequency of the
wave
–100.00 to +100.00
3 Amp V Vertical amplitude of the
wave
0.00 to 100.00
4 Freq V Vertical frequency of the
wave
–100.00 to +100.00
To Next Page
Loading...
Need help?
General