Chapter 4 Keys
255
Key Setting Operations With the Key Control Block
Using the subsidiary mask
In the key control block, press the [SUB MASK] button, turning it on. The
parameter settings depend on the mask source selected as [Wipe] or [Utility 1
Bus] in the <Mask Source> group of the Sub Mask menu for the key.
• When wipe is selected
• When utility 1 bus is selected
Applying a DME Effect to a Key
Notes
For one M/E bank, DME effects (including DME wipes) can be used in up to
two places on the dedicated interface and in only one place on the SDI interface
simultaneously.
When combining the SDI interface with the dedicated interface, you can apply
DME effects to a maximum of three keys. (Requires a setting in setup.)
Assigning a DME to a key
1
In the key control block, press the delegation buttons [M/E1] and [KEY1].
2
Using the DME channel selection buttons, select the DME channel (DME1
to DME8) for applying the effect.
The lit colors of the [DME1] to [DME8] buttons indicate the DME
assignment.
Lit green: Shows the DME assigned to the currently selected key.
Lit amber: Shows the DME assigned to a key other than the currently
selected key.
Off: DME is not assigned.
To select a DME being used by another keyer
Press [Override], turning it on, then select the DME channel.
Knob Parameter Adjustment Setting values
1 Size Pattern size 0 to 100
2 Soft Edge softness 0 to 100
Knob Parameter Adjustment Setting values
1 Clip Reference level for
creating mask signal
+109 to –7
2 Gain Gain –100 (shown as –00) to +100
To Next Page
Loading...
