Chapter 2 Menus and Control Panel
59
Names and Functions of Parts of the Control Panel
Cross-Point Control Block
In the cross-point control block, you can
select the signals to be used in this M/E
bank or PGM/PST bank.
There are also modules without the source
name displays shown in the following
figure.
All operations except those of the [SHIFT]
button are the same as for a module with
source name displays.
a Cross-point buttons
These buttons select the signals used for
video creation on this M/E bank or PGM/
PST bank. Each row of buttons corresponds
to one or more signal buses within the
switcher.
Key 1 row: The buttons in this row select
the key 1 or key 3 signals to be inserted
into the video on this M/E bank or
PGM/PST bank.
To select the key 1 fill signal, check
that the right-hand [KEY3] button in
1 Cross-point buttons
5 Source name displays
7 M/E bank display
3 Key bus selection buttons
4 UTIL button
8 Macro buttons
2 XPT HOLD buttons
6 SHIFT button
Key 1 row
Key 2 row
Reentry buttons
Reentry buttons
Background A row
Background B row
To Next Page
Loading...
