Chapter 2 Menus and Control Panel
60
Names and Functions of Parts of the Control Panel
the M/E bank (or the [DSK3] button in
the PGM/PST bank) is off, then press
the button assigned to the desired
signal. To select the key 3 fill signal,
press the [KEY3] button, turning it on.
While the [UTIL] button on the right
hand side is held down, these buttons
are assigned to the DME external video
bus allowing you to select the signal on
that bus.
Key 2 row: The buttons in this row select
the key 2 or key 4 signals to be inserted
into the video on this M/E bank or
PGM/PST bank.
To select the key 2 fill signal, check
that the right-hand [KEY4] button in
the M/E bank (or the [DSK4] button in
the PGM/PST bank) is off, then press
the button assigned to the desired
signal. To select the key 4 fill signal,
press the [KEY4] button, turning it on.
While the [UTIL] button on the right
hand side is held down, these buttons
are assigned to the DME utility 1 or 2
bus as follows.
• When the [KEY 4] button is off:
DME utility 1 bus
• When the [KEY 4] button is on:
DME utility 2 bus
Background A row: Press the desired
button to select the signal as the current
background video on this M/E bank or
PGM/PST bank.
While the [UTIL] button on the right
hand side is held down in Hold mode,
these buttons are assigned to the utility
1 bus, and can be used to select the
signal on that bus.
Background B row: Press the desired
button to select the signal as the
background video after the transition
on this M/E bank or PGM/PST bank.
While the [UTIL] button on the right
hand side is held down in Hold mode,
these buttons are assigned to the utility
2 bus, and can be used to select the
signal on that bus.
Reentry buttons: These allow you to select
the video created on another bank as
background A or B or one of the keys 1
to 4. For example, to use the video
created on the M/E-1 bank as
background B on the M/E-2 bank, press
the reentry button [M/E 1] in the
background B row of buttons on the M/
E-2 bank.
Cross-point button numbers
Cross-point button and reentry buttons are
respectively numbered.
For details, see “Cross-point button
control block button numbers” (page 151).
Assigning signals to button
You can assign a signal to each button using
the Setup menu.
For details on the operation, see “Cross-
Point Settings (Xpt Assign Menu)” in
Chapter 19 (Volume 3).
Visual indications on cross-point buttons
For details on the operation, see “Colors of
lit cross-point buttons” (page 155).
b XPT (cross-point) HOLD buttons
Turning one of these buttons on enables
you to recall a keyframe or snapshot while
keeping the current cross-point selection
unchanged.
Function of this button varies depending on
the operation mode selected in the Setup
menu.
For details, see “Selecting the Bank to
Make the Settings” in Chapter 20 (Volume
3).
To Next Page
Loading...
