Chapter 13 Keyframe Effects
854
Executing Effects
Setting the Run Mode
You can set the run mode in which an effect is executed when you press the
[RUN] button.
Specifying the effect execution direction
To specify the effect execution direction, press the [NORM] button or the
[REV] button, turning it on. When you press one, turning it on, the other
automatically goes off.
To execute the effect so as to obtain the effects of the [NORM] and [REV]
buttons alternately, press the [NORM/REV] button, turning it on.
When the [NORM] button is lit: The effect is executed in the direction from
the first keyframe to the last keyframe.
When the [REV] button is lit: The effect is executed in the direction from the
last keyframe to the first keyframe.
When the [NORM/REV] button is lit: Each time the effect is executed, the
direction reverses.
Executing an effect up to the next keyframe
1
Press the [STOP NEXT KF] button, turning it on.
2
Press the [RUN] button.
This executes the effect as far as the next keyframe. When the [REV]
button is lit, it is executed as far as the previous keyframe.
Repeating an effect
1
Press the [EFF LOOP] button, turning it on.
2
Press the [RUN] button.
This executes the effect repeatedly, from the first keyframe to the last
keyframe.
When the [REV] button is lit, the effect is executed in the reverse direction.
3
To stop the repeating effect, press the [EFF LOOP] button, turning it off,
or press the [REWIND] button.
To Next Page
Loading...
