Chapter 13 Keyframe Effects
853
Executing Effects
Executing an effect automatically
1
Select the region in which you want to execute the effect, using the region
selection buttons in the numeric keypad control block. (See “Recalling a
register from the numeric keypad control block” (page 816).)
2
With the numeric keypad, enter the number of the register in which the
effect you want to execute is saved, and press the [ENTER] button to
confirm.
This recalls the effect saved in the register.
3
In the keyframe control block, press the [RUN] button.
The [RUN] button lights amber and the effect is executed automatically.
Executing an effect manually
In step 3 above, operate the fader lever.
To use the transition control block fader lever as a keyframe fader
Press the [KF] button in the transition control block, turning it on, to execute a
keyframe effect with the fader lever in the same control block.
You can also assign the [KF] button to a transition type selection button in the
transition control block.
For the operation of assigning the [KF] button to the transition type selection
buttons, see “Overall Control Panel Settings (Config Menu)” in Chapter 19
(Volume 3).
Notes
• It is not possible for the [KF] button to be on for multiple banks (M/E or
PGM/PST) at the same time. If you press the [KF] button in more than one
bank, only the last button pressed remains on.
• If a macro is assigned to the transition control block fader lever, then while
in use as a keyframe fader the macro is not executed.
Moving to the first keyframe of the effect
To move to the first keyframe of the effect, press the [REWIND] button.
Moving to the last keyframe of the effect
To move to the last keyframe of the effect, press the [FF] button.
To Next Page
Loading...
