Chapter 19 Control Panel Setup (Panel)
1138
Overall Control Panel Settings (Config Menu)
1
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2
Press [Fade To Black Module].
The Fade To Black Module menu appears.
On the left of the status area, preview selection buttons (1 to 11) appear.
On the right side a list of signals to be assigned appears.
3
In the button indications on the left, press the button for the assignment.
4
Using any of the following methods, select the signal to be assigned.
• Press directly on the list on the right.
• In the list on the right, press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
5
Press [Set].
This assigns the signal selected in the list to the button.
To cancel an assignment
Select the button, then press [Clear].
This leaves nothing assigned.
To return all preview selection button assignments to the factory
default state
In the Fade To Black Module menu, press [Default].
Assigning Functions to the Device Control Block
Assigning devices or functions to the device selection buttons
and other buttons of the device control block (search dial)
You can assign devices and functions to the device selection buttons, SBOX
buttons and [DELAY] button of the device control block (search dial).
For details of the device control block (search dial), see Chapter 2 (Volume 1).
1
In the Panel >Config menu, press [Link/Program Button].
Knob Parameter Adjustment Setting values
1 Button Button selection 1 to 20
To Next Page
Loading...
