Sony MVS-8000 - Applying a DME Effect to a Key

Chapter 4 Keys
240
Key Setting Operations Using Menus
3 In the <Mask Source> group, select the mask source.
Wipe: wipe pattern selected for a transition
If you select [Wipe], select the pattern and make modifier settings in
the M/E-1 >Wipe menu (see page 289), then return to this M/E-1
>Key1 menu.
In the case of a wipe pattern selected for a mask, the modifier [Edge]
and [Direction] settings are not available.
Utility 1 Bus: signal selected on the utility 1 bus
When you selected [Utility 1 Bus], hold down the [UTIL] button in the
M/E-1 bank cross-point control block, and select the signal with the
background A bus buttons. While the [UTIL] button is pressed, the
background A bus switches to the utility 1 bus.
Notes
To enable the [UTIL] button, its operation mode must be set to [Hold]
beforehand. (See “Operation Settings (Operation Menu)” in Chapter 19
(Volume 3).)
4 Set the mask source parameters.
• When wipe is selected
• When utility 1 bus is selected
5 To invert the black and white sense of the mask source, press the [Mask
Invert] button, turning it on.
Applying a DME Effect to a Key
Notes
For one M/E bank, DME effects (including DME wipes) can be used in up to
two places on the dedicated interface and in only one place on the SDI interface
simultaneously.
Knob Parameter Adjustment Setting values
1 Size Pattern size 0.00 to 100.00
2 Soft Edge softness 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Clip Reference level for creating mask
signal
+109.59 to –7.31
2 Gain Gain –100.00 to +100.00