Chapter 11 DME Operations
691
DME Special Effect Operations
To make the tip of the swirl stardust
1
Press [Pixel], turning it on.
2
Set the following parameters.
Corner Pinning Settings
Notes
• The Corner Pinning function is not supported on the MVE-8000.
• When the Brick effect is enabled, the Corner Pinning function cannot be
used.
Setting the Foreground Corner Pinning positions
1
In the DME menu, select VF4 ‘Non Linear/Corner Pin’, HF2 ‘Corner
Pinning.’
The Corner Pinning menu appears.
2
Set [Corner Pinning] to On.
3
Set [Corner Marker] to On.
A marker appears for each corner. The marker for the selected corner is
distinguished from the other markers.
4
In the <Corner Select> group, select the corner to operate on.
Top Left: Top left
Top Right: Top right
Bottom Left: Bottom left
Knob Parameter Adjustment Setting values
1 Density Degree to which image disappears 0.00 to 100.00
2 Random Trail type and amount of stardust 0.00 to 100.00
Marker for selected corner
Other markers
To Next Page
Loading...
