Chapter 3 Signal Selection and Transitions
191
Independent Key Transitions
Basic Independent Key Transition Operations
Independent key transition control block (standard type)
To set independent transitions for the keyers on the M/E or PGM/PST bank,
use the independent key transition control block.
1
Select one or more of the delegation buttons [KEY1] to [KEY4] ([DSK1]
to [DSK4] in the PGM/PST bank), turning them on.
You can press more than one button at the same time.
2
Select the transition type.
To fade a key in or out: Press the [MIX] button, turning it on.
To insert or delete a key using a dedicated wipe pattern: Press the
[WIPE] button, turning it on.
To insert or delete a key using a dedicated DME wipe pattern: Press
the [DME] button, turning it on.
If, in the Setup menus, you set insertion and deletion as independent
modes, make the settings for the next transition in the independent key
transition control block.
Separate settings are required both when inserting a key and when deleting
it. For example, with the key not inserted, if you select the transition type
and carry out a transition, this will be the setting when inserting a key.
You can also use the Transition menu to select a desired independent key
transition type for each key (see the next section).
Independent key transition type
selection buttons
Independent key transition
execution section
Key delegation buttons
Key source name display/key
snapshot buttons
To Next Page
Loading...
