Chapter 3 Signal Selection and Transitions
152
Signal Selection
Notes
On the MVS-8000A/8000G, you can use the rightmost button (number 32) as
a [SIDE FLAG] button. In this case, the shift button moves one to the left, to
number 31, and the button numbers are offset by one.
For details of the [SIDE FLAG] button, see “Cross-Point Settings (Xpt Assign
Menu)” in Chapter 19 (Volume 3).
Switching button numbers
The rightmost (32nd) button functions as a shift button.
(The shift button function can be disabled in a Setup menu.)
When selecting the signals of button numbers 1 to 31, press the cross-point
button for the desired signal.
To select button numbers 32 to 62, hold down the shift button, and press the
cross-point button for the desired signal.
Button numbers in the auxiliary bus control block
When the [2ND] button is unlit
The cross-point buttons and reentry buttons in the auxiliary bus control block
have separate upper (1st row) and lower (2nd row) numbers.
In the case of a 32-button layout, the button numbers are as follows.
(1st row)
(2nd row)
[2ND] button
Auxiliary bus control block button numbers ([2ND] button unlit)
Button Button Button numbers
1st row From the left end to the 31st button 1 to 31
Reentry buttons 121 to 124
2nd row From the left end to the 31st button 32 to 62
Reentry buttons 125 to 128
To Next Page
Loading...
