Chapter 19 Control Panel Setup (Panel)
1128
Overall Control Panel Settings (Config Menu)
3
Press the indication of the button for the assignment.
The button you pressed appears in reverse video.
4
Using any of the following methods, select one of the four regions for the
setting.
• Press directly on the list in the upper part of the right side.
• Press the arrow keys to scroll the reverse video cursor in the list in the
upper part of the right side.
• Turn the knob.
5
Using any of the following methods, select the region to be assigned.
• Press directly on the list in the lower part of the right side.
• Press the arrow keys to scroll the reverse video cursor in the list in the
lower part of the right side.
• Turn the knob.
6
Press [Set], to confirm the selection.
This assigns the region to the region selection button in the numeric
keypad control block.
Notes
Only regions assigned here can be used for keyframe or snapshot recall.
If an M/E bank is not assigned to a region selection button in the numeric
keypad control block or Multifunction Flexi Pad control block, the M/E Flexi
Pad control block or Multifunction Flexi Pad control block cannot be used to
recall a snapshot.
To return the region assignment to the factory default state
In the Panel >Config >10 Key Region Assign menu, press [Default].
This returns the assignment of region selection buttons in the numeric keypad
control block to the factory default state.
To delete a region assignment
In step 3 of the procedure “Assigning a Region to the Region Selection Buttons
in the Numeric Keypad Control Block or Multifunction Flexi Pad Control
Block” (page 1126), make the selection to which the operation applies, then
press [Clear].
Knob Parameter Adjustment Setting values
1 Button Assign Selection to which setting
applies
1 to 4
Knob Parameter Adjustment Setting values
2 Region Region selection 1 and upwards
To Next Page
Loading...
