Chapter 19 Control Panel Setup (Panel)
1152
Cross-Point Settings (Xpt Assign Menu)
Creating tables 1 to 14
When creating tables 1 to 14, in the same way as when creating the main table,
you can assign the same signal to more than one button number, or delete
currently assigned signals. However, assignment of video and key
combinations is impossible.
1
In the Panel >Xpt Assign menu, press [Table Button Assign].
The Table Button Assign menu appears.
The table number appears on the upper left part of the status area.
The left part of the status area shows the cross-point button numbers, video
and key pair numbers, video signal source names and source numbers, and
key signal source names and source numbers. When the shift button is
pressed, the number column is distinguished by color.
The right part shows the video and key pair numbers, and the names of
video signals and key signals set in the main table.
The Table Button Assign menu also allows you to access the Main, V/K
Pair Assign menu and the Src Name/LCD Color menu.
2
Using the knob, select the table number.
3
Using any of the following methods, select the button number.
• Press an auxiliary bus control block cross-point button.
(The auxiliary bus control block is in selection mode, only when the
menu for cross-point button selection is showing.)
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
4
Using any of the following methods, select the pair number.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment Setting values
1 Ta bl e No Selection of the table to be set 1 to 14
Knob Parameter Adjustment Setting values
2 Button No Cross-point button selection 1 to 128
Knob Parameter Adjustment Setting values
3 V/K Pair No Selection of video and key pair
number to be assigned
1 to 128
To Next Page
Loading...
