Chapter 20 Switcher Setup (Switcher)
1209
Settings for Switcher Configuration (Config Menu)
Adjusting the width of the side flags
You can adjust the width of the side flags.
1
In the Switcher >Config >Side Flags menu, press [Width].
2
Adjust the following parameters.
Displaying the menu for enabling/disabling the side flags
In the Switcher >Config >Side Flags menu, press [Misc >Enbl >Setup Flags].
Displaying the menu for assigning the side flags on/off function
to a cross-point button
In the Switcher >Config >Side Flags menu, press [Side Flags Button Assign].
Knob Parameter Adjustment Setting values
3 Left Width of left side flag –100.00 to +100.00
4 Right Width of right side flag –100.00 to +100.00
5 All Width of both side flags Left value shown
To Next Page
Loading...
