Chapter 22 DCU Setup (DCU)
1275
GPI Output Setting (GPI Output Assign Menu)
• Action list when the trigger type is “Status”
When Source Device is SCU: M/E1 Key1 SS ? Recall, M/E1 Key2 SS ? Recall, M/E1
Key3 SS ? Recall, M/E1 Key4 SS ? Recall
M/E2 Key1 SS ? Recall, M/E2 Key2 SS ? Recall, M/E2 Key3 SS ? Recall, M/E2
Key4 SS ? Recall
M/E3 Key1 SS ? Recall, M/E3 Key2 SS ? Recall, M/E3 Key3 SS ? Recall, M/E3
Key4 SS ? Recall
P/P DSK1 SS ? Recall, P/P DSK2 SS ? Recall, P/P DSK3 SS ? Recall, P/P DSK4
SS ? Recall
M/E1 Key1 On, M/E1 Key2 On, M/E1 Key3 On, M/E1 Key4 On
M/E2 Key1 On, M/E2 Key2 On, M/E2 Key3 On, M/E2 Key4 On
M/E3 Key1 On, M/E3 Key2 On, M/E3 Key3 On, M/E3 Key4 On
P/P DSK1 On, P/P DSK2 On, P/P DSK3 On, P/P DSK4 On
Error Make, Error Break, Keep Break, Keep Make, Device Recording, No Action
When Source Device is DCU: Error Make, Error Break, No Action
b) When knob 2 selection is “Key Snapshot”
c) When knob 2 selection is “GPI”
6
To confirm the selection, press [Action Set].
This confirms the selection, which appears in the status area.
Test firing the trigger
To test fire the trigger, in the DCU >GPI Output menu press [Test Fire].
This outputs a trigger from the selected output port. This is not output when the
trigger type is “Status.”
To Next Page
Loading...
