Chapter 3 Signal Selection and Transitions
163
Key Priority Setting
Transition control block (standard type)
Changing the currently inserted key priority
1
If the next transition selection button [KEY PRIOR] is on, press another
next transition selection button to turn the [KEY PRIOR] button off.
(When the [KEY PRIOR] button is on, the transition control block
switches to the mode for changing the key priority for after the transition.)
2
Holding down the [PRIOR SET] button, press the one of the next transition
selection buttons [KEY1] to [KEY4] ([DSK1] to [DSK4] buttons in the
PGM/PST bank) for the key to appear on top.
The selected key now appears on top, on the program monitor.
The priority of keys other than the selected one does not change.
To change the priority of more than one key, repeat this operation as
required.
Next transition
selection buttons
KEY PRIOR button
PRIOR SET button
Key 1 selected.
Key priority: 3, 1, 4, 2
Key priority: 1, 3, 4, 2
To Next Page
Loading...
