Sony MVS-8000 - Page 234

Chapter 4 Keys
234
Key Setting Operations Using Menus
• When applying a border to the key edge, enabling the [Fine Key]
function halves the border width setting range.
To fix key fill and key source in key drop off mode
1 In the Edge menu, press [Key Delay Mode].
The Key Delay Mode menu appears.
Notes
This function is only supported on the MVS-8000G.
2 Press [Frame Delay], setting it to On.
Notes
This function uses the resizer, and therefore the expected result of the
setting may not be obtained if conditions do not allow the resizer to be
used.
Carrying out a color mix for the key edge fill matte
When you select ‘Matte’ for the edge fill of a border, drop border, or shadow,
you can create a combination of color 1 and color 2 using a wipe pattern
generated by the dedicated pattern generator.
1 In the <Edge Fill> group of the Edge menu, select [Matte], then press
[Matte Adjust].
The edge fill Matte Adjust menu appears.
2 In the <Edge Matte> group, select [Mix Color], turning it on.
3 Adjust the following parameters.
a) The patterns are the same as standard wipes. (For details, see “Wipe Pattern List” in (page
522).)
To select the pattern, display the Mix Pattern Select menu by pressing
[Mix Pattern] in the edge fill Matte Adjust menu. After selecting one of the
Knob Parameter Adjustment Setting values
1 Size Pattern size 0.00 to 100.00
2 Soft Softness of pattern edge 0.00 to 100.00
3 Pattern Pattern number
1 to 24
a)