Chapter 4 Keys
236
Key Setting Operations Using Menus
• When turning [Angle] on in the <Rotation> group and inclining the
pattern
a) See page 304.
• When turning [Speed] on in the <Rotation> group and rotating the
pattern at a constant speed
a) See page 305.
6
To interchange color 1 and color 2, press [Color Invert], turning it on.
Applying the zabton effects
1
In the Edge menu, press [Zabton], turning it on.
2
Adjust the following parameters.
Notes
If in the pattern selection described below you select “Mask Pattern,” and
“Box” for the main mask, the “Size” parameter here cannot be adjusted.
Set “Size” in the Main Mask menu.
3
To adjust the pattern and color, press [Zabton Adjust].
The Zabton Adjust menu appears.
4
In the <Zabton Pattern> group, select the pattern.
Key Wipe: Use a key wipe.
You can change this pattern by pressing [Pattern Select] to open the menu
for key wipe pattern selection (Pattern Select menu), and make
adjustments by pressing [Pattern Adjust] to open the menu for pattern
adjustment (Wipe Adjust menu).
Knob Parameter Adjustment Setting values
1 Angle Angle of pattern rotation
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Speed Rotation rate of pattern
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Size Pattern size 0.00 to 100.00
2 Soft Pattern edge softness 0.00 to 100.00
3 Density Density 0.00 to 100.00
To Next Page
Loading...
