Chapter 4 Keys
249
Key Setting Operations With the Key Control Block
When using a color matte: Press the [MATTE FILL] button, setting it on. The
button lights green, and you can now set the parameters with the knobs.
When [Mix Color] is selected in the key fill Matte Adjust menu, you can
further adjust color 2.
When [Mix Color] is on, and the [MORE] button is lit amber
When [Mix Color] is on, and the [MORE] button is lit green
When using the key fill bus signal: Press the [MATTE FILL] button, turning
it off.
To select the key fill signal, use the key 1 or key 2 bus buttons in the cross-
point control block.
To select the key fill signal for key 3 or key 4 in the cross-point control
block, press the [KEY3] button or [KEY4] button to the right of the key
bus buttons, turning it on, to allocate the key 1 bus row or key 2 bus row
to the key 3 fill bus or key 4 fill bus, then press the desired cross-point
button.
For the CCP-6224/6324 Control Panel, it is necessary to set the [AUX
CTRL] button to Off in order to exit the AUX panel-less function (see page
150).
Selecting key source
• To use the key source paired with the key fill signal selected on the key fill
bus, press the [AUTO SEL] button, turning it on. The pairing of the cross-
point buttons for key fill and key source is carried out in the Setup menu. (See
“Cross-Point Settings (Xpt Assign Menu)” in Chapter 19 (Volume 3).)
Knob Parameter Adjustment Setting values
1 Luminance Color 1 luminance 0 to 100
2 Saturation Color 1 saturation 0 to 100
3 Hue Color 1 hue 359 to 0
Knob Parameter Adjustment Setting values
1 Luminance Color 1 luminance 0 to 100
2 Saturation Color 1 saturation 0 to 100
3 Hue Color 1 hue 359 to 0
4 Size Pattern size 0 to 100
Knob Parameter Adjustment Setting values
1 Luminance Color 2 luminance 0 to 100
2 Saturation Color 2 saturation 0 to 100
3 Hue Color 2 hue 359 to 0
4 Soft Edge softness 0 to 100
To Next Page
Loading...
