Chapter 4 Keys
283
Key Snapshots
Key snapshot operation on the Multifunction Flexi Pad control
block
By default, the [KEY SS] key snapshot mode selection button does not appear
in the Multifunction Flexi Pad control block. To carry out key snapshot saving
and recall in this control block, it is first necessary in the Engineering Setup
>Panel >Config >Link/Program Button >Multi Function >Mode Sel Assign
menu to assign the Key Snapshot mode to a mode selection button.
To save a key snapshot
For example, to save a key snapshot for key 1 of M/E-1, select M/E1 and key1,
then use the following procedure.
1
Press the [K SS] button.
The button displays in the memory recall section change as shown in the
following illustration.
2
In the memory recall section, hold down the [STOR] button, and press the
button (any of [1] to [4]) for the register in which you want to save the key
snapshot.
To recall a key snapshot
For example, to recall a key snapshot for M/E1 key 1 saved in register 1, with
the M/E1 region and key 1 selected, proceed as follows.
1
Press the [KEY SS] button.
2
According to the information you want to recall, set the following buttons
On/Off.
[MOD ENBL] button: Recall the key adjustment values and key modifier
settings.
To Next Page