Chapter 5 Wipes
290
Basic Procedure for Wipe Settings
3
Press the button to select the desired pattern.
The selected pattern is displayed on the screen.
4
The parameters change according to the selected pattern, and you can
adjust the pattern.
• When a polygon wipe is selected (pattern number 49)
a) A value of –100.00 completely removes the star “rays,” leaving a circle; at +100.00 the
“rays” are at their sharpest.
• When a mosaic wipe is selected (pattern numbers 200 to 203, 206 to
213, 224 to 247, 250 to 257, 260 to 269)
• When a karaoke wipe is selected (pattern numbers 220 to 223)
a) At –100.00 tiles appear from the top (or left edge) of the screen; at +100.00 from the
bottom (or right edge) of the screen.
b) At –100.00 all rows appear simultaneously; at +100.00 until one row of tiles is completely
displayed, the next row does not start to appear.
• When a random wipe is selected (pattern number 273)
• When a diamond dust wipe is selected (pattern number 274)
Knob Parameter Adjustment Setting values
1 No Number of points 3 to 64
2 Star Rate Angularity of star
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 H Tile No Number of tiles horizontally 2 to 36
2 V Tile No Number of tiles vertically 2 to 18
Knob Parameter Adjustment Setting values
1 Start Position of start tile
–100.00 to +100.00
a)
2 Row No Number of rows of tiles 1 to 36
3 Phase Delay for next row
–100.00 to +100.00
b)
Knob Parameter Adjustment Setting values
1 H Size Tile width 0.00 to 100.00
2 V Size Tile height 0.00 to 100.00
3 Volatility Rate of tile generation 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 H Size Particle width 0.00 to 100.00
2 V Size Particle height 0.00 to 100.00
3 Flash Rate Rate of generation of particles 0.00 to 100.00
To Next Page
Loading...
