Sony MVS-8000 - Page 475

Chapter 9 Color Corrector
475
Color Corrector Functions
The Luminance Process menu appears.
2 In the <Luminance Process> group, press [Luminance Process], turning it
on.
3 In the <Mode> group, specify the adjustment mode.
Tint: add a specified color to the original video signal.
Color Modify: adjust the original video signal.
Y Modify: adjust the output levels of the input luminance signal.
When tint mode or color modify mode is selected, skip to step 4.
When Y modify mode is selected, adjust the following parameters.
4 In the <Bound> group, make the settings for the three regions (Dark,
Middle, and Bright).
• [Level] parameters: set the boundaries of the three regions.
• [Soft] parameters: set the degree of boundary softness of the three
regions.
Knob Parameter Adjustment Setting values
1 White White balance adjustment 0.00 to 200.00
2 Black Black balance adjustment –100.00 to +100.00
3 Y Lift Curvature of curve –100.00 to +100.00
4 Y Dark Position of maximum point of
curve
–7.31 to +109.59
Knob Parameter Adjustment Setting values
1 Over B Level Luminance level of the Over
Bright point
50.00 to 150.00
2 Mid B Level Luminance level of the Bright/
Middle point
10.00 to 120.00
3 Dark Mid
Level
Luminance level of the Middle/
Dark point
–20.00 to +90.00
4 Under D
Level
Luminance level of the Under
Dark point
–50.00 to +50.00
Knob Parameter Adjustment Setting values
1 Over B Soft Degree of softness at Over Bright
point
15.00 to 70.00
2 Mid B Soft Degree of softness at Bright/
Middle point
15.00 to 42.50
3 Dark Mid
Soft
Degree of softness at Middle/Dark
point
15.00 to 42.50