Chapter 10 Special Functions
513
3D Support
2
Press [3D Mode], turning it on.
A popup window appear, with a message.
3
Check the message, and select [Yes].
This switches the system to 3D mode.
Setting input signals for 3D mode
Input primary numbers for left and right signals
The primary input numbers are set for each of the signals used in 3D mode for
the left eye view and right eye view (referred to simply as left and right
signals).
For example, if the left signal is input to PRIMARY INPUT 1, the right signal
must be input to PRIMARY INPUT 18.
For some signals, such as titles, the same signal is used for both left and right.
For each primary input, to select whether separate left and right signals are
used, or the same signal is shared between left and right, use the following
procedure.
1
Display the Engineering Setup >Switcher > Config >3D Config menu.
2
Press [Input Link].
The Input Link menu appears.
To Next Page
Loading...
