Chapter 10 Special Functions
516
3D Support
Setting frame memory outputs for 3D mode
Select whether to use frame memory outputs 1 to 8 in combinations of left and
right signals for 3D mode. The left and right combinations are fixed, as 1 and
5, 2 and 6, 3 and 7, and 4 and 8.
1
Display the Engineering Setup >Switcher >Config >3D Config menu.
2
Press [FM Output Link].
The FM Output Link menu appears.
3
Using any of the following methods, select the link number.
• Press directly on the list.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
4
Press [FM Link], and set the link to either of the following.
• To use the frame memory outputs in left and right combinations, set to
On.
• To use the same frame memory output for left and right, set to Off (no
indication).
Knob Parameter Setting Values
1 Link No Link number 1 to 8
3 Num Select the number of consecutive
numbers from the selected link number
1 to 8
Link number
Using two signals in left-right
combination
Using one signal shared between
left and right
To Next Page
Loading...
