Chapter 11 DME Operations
658
DME Special Effect Operations
a) This setting value is not supported on the MVE-8000A.
• 16:9 mode
a) This setting value is not supported on the MVE-8000A.
5
To invert the mask source, press [Invert], turning it on.
6
As required, set the modifiers for the mask pattern.
• When turning [Aspect] on and adjusting the pattern aspect ratio
a) When a minus value is specified, the picture is extended in the vertical direction. When a
plus value is specified, the picture is extended in the horizontal direction.
• When turning [Angle] on in the <Rotation> group and slanting the
pattern
a) –1.00 is one rotation in counterclockwise direction. +1.00 is one rotation in clockwise
direction. 0.00 is no rotation.
• When turning [Speed] on in the <Rotation> group and rotating the
pattern at a specified speed
a) –100.00 is four rotations per second in counterclockwise direction. +100.00 is four
rotations per second in clockwise direction. 0.00 is no rotation.
Notes on applying a mask effect with a DME (only when using the
MVE-9000)
In the <Mask> group of the DME >Video Modify >Mask menu, if [Effect Gp1]
and [Effect Gp2] are simultaneously set to On, then the border or beveled edge
is also masked.
The following explains this with the example of using a circular mask pattern.
Knob Parameter Adjustment Setting values
1 H Horizontal position –8.00 to +8.00 (SD)
–32.00 to +32.00 (HD)
2 V Vertical position –4.50 to +4.50 (SD)
–18.00 to +18.00 (HD)
3 Size Size of mask 0.00 to 100.00
4 Soft Softness of mask 0.00 to 100.00
5 Pattern Pattern number
21, 24, 304
a)
Knob Parameter Adjustment Setting values
1 Aspect Aspect ratio
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Angle Rotation angle of pattern
–8.00 to +8.00
a)
Knob Parameter Adjustment Setting values
1 Speed Rotation speed of pattern
–100.00 to +100.00
a)
To Next Page
Loading...
