Chapter 11 DME Operations
660
DME Special Effect Operations
Time Strobe: Freezes the input video at specified intervals for a specified
length.
Film: Slows the apparent frame rate, for an effect like film. You can specify
the ratio of advancement.
For Hard Freeze and Time Strobe, you can select the first field or the frame as
the freeze timing.
Notes
When 720P signal format is used, the Film mode cannot be selected.
To apply a Freeze effect, start by displaying the Freeze menu. In the DME
menu, select VF3 ‘Freeze’ and HF1 ‘Freeze.’
Applying the Hard Freeze effect
1
In the <Freeze Timing> group, select the signal freeze timing.
Frame: Freeze one frame of signal.
Field 1: Freeze the first field of signal.
Notes
During the execution of a freeze with the MVE-8000, you cannot change
the freeze timing.
2
In the <Freeze> group, press [Hard Freeze], turning it on.
The Hard Freeze is executed, displaying a still image.
Applying the Time Strobe effect
1
In the <Freeze Timing> group, select the signal freeze timing.
Frame: Freeze one frame of signal.
Field 1: Freeze the first field of signal.
Notes
• During the execution of a freeze with the MVE-8000, you cannot change
the freeze timing.
• The freeze timing setting is not required when the following signal
formats are being used.
Signal formats: 1080PsF/30, 1080PsF/29.97, 1080PsF/25, 1080PsF/24,
1080PsF/23.976, 720P/59.94, 720P/50
2
In the <Freeze> group, press [Time Strobe], turning it on.
To Next Page
Loading...
